Jump In tranny tube xxx exclusive watching. On the house on our video portal. Engage with in a massive assortment of featured videos presented in superior quality, the best choice for premium viewing lovers. With up-to-date media, you’ll always be in the know. Experience tranny tube xxx recommended streaming in impressive definition for a remarkably compelling viewing. Connect with our online theater today to see VIP high-quality content with free of charge, registration not required. Get access to new content all the time and journey through a landscape of indie creator works built for deluxe media addicts. Grab your chance to see original media—click for instant download! Access the best of tranny tube xxx singular artist creations with amazing visuals and chosen favorites.
Here is an easy one Or is there a better option out there My tranny gasket was about gone so i replaced it
I dropped the pan, changed the filter and gasket and then replaced the pan I'm considering the hughes, tci, and b&m kits I put four qaurts dextron/mercron iii tranny fluid into it
Started motor, let it get hot, shifted through all gears and checked the fluid level.
The tranny is marked as I have a '67 chevelle coupe I am running a 350 with about 375 hp I am getting ready to install a new th350 tranny and 2200 stall torque converter
I plan up upgrading the stock radiator to an aluminum aftermarket (like be cool or griffin) Do i need a trans cooler If so, where do you. I've hear 400 turbo transmission and 700r transmission
Looking to buy a new one rather then a rebuilt one
It would be used as a daily driver and cruiser. I have a b&m 400 trans in my car It was from another project and has about 200 miles on it After 15 years i have it in my car
It is pretty much empty How much fluid does it hold And how much should i put in for start up. This tranny is about 1 1/2 years old and probably doesn't have 1500 miles on the rebuild
It is an '89 model
I had it completely gone thru with the typical extra clutch packs, corvette servo, new reaction shield (?) and a transgo shift kit, etc It was built by the highest regarded. Last time i left the transmission in the car, which was a little difficult to line up with the transmission (oilpan clearing the crossmember and flexplate clearing the bellhousing) But i was able to leave the driveshaft, cooler lines, shifter cable all attached, loosened the trans mount and placed a jack under the trans (with wood blocking to spread the load).i have a plastic transmission.
My th350 tranny cooler lines are old and one of them has a kink in it I was considering ripping out all the old steel line and running braided tranny lines with an fittings Just curious what a good size of braided line to run would be and what size an fittings would i need that would screw. I haven't done a tranny yet today so i'm foggy on the bolts but i damsure remember that there is a metric mess that can happen to you
An american bolt will go right in but feels sloppy.
I'm about 2 weeks away from dropping a 500hp 454 in my '70 elky and i have concerns about the tranny holding up under the new power plant Is a rebuild in order Which kit is the best
OPEN
